Back to browse
PCBM_WIZNET_WIZ140SR_a
Quad Serial to Ethernet Module Based on W5300 & Cortex-M3
Schematic Symbol
Pin Configuration (42 pins)
| Pin | Name | Type |
|---|---|---|
| J1-1 | 3.3V | power_in |
| J1-2 | 3.3V | power_in |
| J1-3 | ~{RESET} | input |
| J1-4 | GND | power_in |
| J1-5 | UART1_RX | input |
| J1-6 | UART1_CTS | input |
| J1-7 | UART1_TX | output |
| J1-8 | UART1_RTS | output |
| J1-9 | STATUS_1 | output |
| J1-10 | GND | power_in |
| J1-11 | UART2_RX | input |
| J1-12 | UART2_CTS | input |
| J1-13 | UART2_TX | output |
| J1-14 | UART2_RTS | output |
| J1-15 | STATUS_2 | output |
| J1-16 | GND | power_in |
| J1-17 | UART3_RX | input |
| J1-18 | UART3_CTS | input |
| J1-19 | UART3_TX | output |
| J1-20 | UART3_RTS | output |
| J1-21 | STATUS_3 | output |
| J1-22 | GND | power_in |
| J1-23 | UART4_RX | input |
| J1-24 | UART4_CTS | input |
| J1-25 | UART4_TX | output |
| J1-26 | UART4_RTS | output |
| J1-27 | STATUS_4 | output |
| J1-28 | GND | power_in |
| J2-1 | SW_INPUT | input |
| J2-2 | HW_TRIGGER | input |
| J2-3 | UART0_TX | output |
| J2-4 | UART0_RX | input |
| J2-5 | BOOT | input |
| J2-6 | TPTX- | output |
| J2-7 | TPTX+ | output |
| J2-8 | PWFBOUT | power_in |
| J2-9 | GND | power_in |
| J2-10 | TPRX- | input |
| J2-11 | TPRX+ | input |
| J2-12 | GND | power_in |
| J2-13 | ~{LINK_LED} | output |
| J2-14 | ~{ACT_LED} | output |
Footprint
This symbol has no default footprint. It's typically a generic part where the footprint depends on the package you choose.