Components
315 matching
Each one is a symbol, its recommended footprint and its 3D package model, linked by KiCad's own references and cross-checked pin by pin.
OPA810xDBV
Amplifier_Operational
140-MHz, Rail-to-Rail Input and Output, FET-Input Operational Amplifier, SOT-23-5
- Pins
- 5
- Pads
- 5
- SMD
- 4.1×3.4
TLC27M2xPW
Amplifier_Operational
LinCMOS Precision Dual Operational Amplifiers, VIO_max = 10mV (at 25°C), VDD = 3..16V (C suffix) / VDD = 4..16V (I / M suffix), 525kHz unity-gain bandwidth (VDD = 5V, TA = 25°C), TSSOP-8
- Pins
- 8
- Pads
- 8
- SMD
- 7.7×3.5
TLV9061xDPW
Amplifier_Operational
10-MHz, RRIO, CMOS Operational Amplifiers for Cost-Sensitive Systems, X2SON
- Pins
- 5
- Pads
- 5
- SMD
- 1.8×1.3
ADG633YCP
Analog_Switch
Triple SPDT CMOS Analog Switch, 52Ohm Ron, LFCSP-16
- Pins
- 17
- Pads
- 17
- SMD
- 5.2×5.2
LP3947
Battery_Management
Single Cell Li-Ion LDO Battery Charger IC, Up to 1A, Support USB charging scheme
- Pins
- 15
- Pads
- 15
- SMD
- 4.9×4.5
MCP73831-3-OT
Battery_Management
Single cell, Li-Ion/Li-Po charge management controller, 4.35V, Tri-State Status Output, in SOT23-5 package
- Pins
- 5
- Pads
- 5
- SMD
- 4.1×3.4
MCP73832-5-OT
Battery_Management
Single cell, Li-Ion/Li-Po charge management controller, 4.50V, Open-Drain Status Output, in SOT23-5 package
- Pins
- 5
- Pads
- 5
- SMD
- 4.1×3.4
MCP73871-3CA
Battery_Management
Single cell, Li-Ion/Li-Po charge management controller, 4.35V, 6h safety timer
- Pins
- 21
- Pads
- 21
- SMD
- 5.2×5.2
MCP6561U
Comparator
Single 1.8V Low-Power Push-Pull Output Comparator, SOT-23-5
- Pins
- 5
- Pads
- 5
- SMD
- 4.1×3.4
RPM3.3-3.0
Converter_DCDC
3A non-isolated switching regulator power module, 3-17V input voltage, 3.3V output voltage, DOSA
- Pins
- 25
- Pads
- 25
- SMD
- 14.2×14.2
ESH2PB
Diode
100V 2A High Voltage Ultrafast Diode, 25ns reverse recovery time, SMP
- Pins
- 2
- Pads
- 2
- SMD
- 4.6×3.0
ESH2PD
Diode
200V 2A High Voltage Ultrafast Diode, 25ns reverse recovery time, SMP
- Pins
- 2
- Pads
- 2
- SMD
- 4.6×3.0
MCP25625x-x-SS
Interface_CAN_LIN
Stand-Alone CAN Controller with SPI Interface and integated Transceiver, SSOP-28
- Pins
- 28
- Pads
- 28
- SMD
- 9.4×10.7
MCP23017x-x-SS
Interface_Expansion
16-bit I/O expander, I2C, interrupts, w pull-ups, SSOP-28
- Pins
- 28
- Pads
- 28
- SMD
- 9.4×10.7
SC16IS752IPW
Interface_UART
Dual UART with I2C/SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support, TSSOP-28
- Pins
- 28
- Pads
- 28
- SMD
- 7.7×10.2
SC16IS762IPW
Interface_UART
Dual UART with I2C/SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support, TSSOP-28
- Pins
- 28
- Pads
- 28
- SMD
- 7.7×10.2
MCP2221AxSL
Interface_USB
USB to I2C/UART Protocol Converter with GPIO, SOIC-14
- Pins
- 14
- Pads
- 14
- SMD
- 7.4×9.2
ATmega48PA-A
MCU_Microchip_ATmega
20MHz, 4kB Flash, 512B SRAM, 256B EEPROM, TQFP-32
- Pins
- 32
- Pads
- 32
- SMD
- 10.3×10.3
LPC11U22FBD48-301
MCU_NXP_LPC
32-bit ARM Cortex-M0 microcontroller, USB, 16KB flash, 8KB SRAM
- Pins
- 48
- Pads
- 48
- SMD
- 10.3×10.3
MC9S08AW32xPUE
MCU_NXP_S08
8-bit General Purpose Microcontroller, S08 core, 32kB Flash, 2kB RAM, LQFP-64
- Pins
- 64
- Pads
- 64
- SMD
- 13.4×13.4
STM32MP133DAGx
MCU_ST_STM32MP1
STMicroelectronics Arm Cortex-A7 MCU, 0KB flash, 168KB RAM, 136 GPIO, TFBGA289
- Pins
- 289
- Pads
- 289
- SMD
- 11.0×11.0
STM32MP153CADx
MCU_ST_STM32MP1
STMicroelectronics Arm Cortex-A7 MCU, 0KB flash, 708KB RAM, 98 GPIO, TFBGA257
- Pins
- 257
- Pads
- 257
- SMD
- 12.0×12.0
STM32U031F6Px
MCU_ST_STM32U0
STMicroelectronics Arm Cortex-M0+ MCU, 32KB flash, 12KB RAM, 17 GPIO, TSSOP20
- Pins
- 20
- Pads
- 20
- SMD
- 7.7×7.0
MSP430F123IRHB
MCU_Texas_MSP430
8kB + 256B Flash, 256B RAM, QFN-32
- Pins
- 28
- Pads
- 33
- SMD
- 6.3×6.3