Components
319 matching
Each one is a symbol, its recommended footprint and its 3D package model, linked by KiCad's own references and cross-checked pin by pin.
MCP6L02x-xMS
Amplifier_Operational
Dual, 1 MHz, 85µA, Rail-to-Rail input and output, MSOP-8
- Pins
- 8
- Pads
- 8
- SMD
- 6.4×3.5
MAX14778
Analog_Switch
Dual ±25V Above- and Below-the-Rails 4:1 Analog Multiplexer, TQFN-20
- Pins
- 21
- Pads
- 21
- SMD
- 6.2×6.2
MAX324CUA
Analog_Switch
Dual SPST CMOS Analog Switches, normally ON, 60Ohm Ron, MSOP-8
- Pins
- 8
- Pads
- 8
- SMD
- 6.4×3.5
MAX1873REEE
Battery_Management
Charger for 2 lithium-ion (Li+), 5/6 NickelCadium (NiCD) cells or 5/6 NickelMetalHydride (NiMH), 9 to 28V VDD, -40 to +85 degree Celsius, QSOP-16
- Pins
- 16
- Pads
- 16
- SMD
- 7.4×5.4
MCP73831-3-OT
Battery_Management
Single cell, Li-Ion/Li-Po charge management controller, 4.35V, Tri-State Status Output, in SOT23-5 package
- Pins
- 5
- Pads
- 5
- SMD
- 4.1×3.4
MCP73832-5-OT
Battery_Management
Single cell, Li-Ion/Li-Po charge management controller, 4.50V, Open-Drain Status Output, in SOT23-5 package
- Pins
- 5
- Pads
- 5
- SMD
- 4.1×3.4
MCP73871-3CA
Battery_Management
Single cell, Li-Ion/Li-Po charge management controller, 4.35V, 6h safety timer
- Pins
- 21
- Pads
- 21
- SMD
- 5.2×5.2
MCP6561U
Comparator
Single 1.8V Low-Power Push-Pull Output Comparator, SOT-23-5
- Pins
- 5
- Pads
- 5
- SMD
- 4.1×3.4
MIC845N
Comparator
Micro-Power Comparator / Battery Monitor, Active-High Open-Drain Output, SC-70-5
- Pins
- 5
- Pads
- 5
- SMD
- 2.9×2.2
MCIMX6D6AVT
CPU_NXP_IMX
i.MX 6Dual Automotive and Infotainment Application Processor, BGA-624
- Pins
- 624
- Pads
- 624
- SMD
- 23.0×23.0
MCL4148
Diode
75V 0.2A Switching Diode, MicroMELF
- Pins
- 2
- Pads
- 2
- SMD
- 2.9×1.7
MRA4007T3G
Diode
1000V, 1A, General Purpose Rectifier Diode, SMA(DO-214AC)
- Pins
- 2
- Pads
- 2
- SMD
- 7.0×3.5
MAX1969xUI
Driver
Power Driver for Peltier TEC Modules, 6A, HTSSOP-28
- Pins
- 29
- Pads
- 29
- SMD
- 7.7×10.2
MAX297xSA
Filter
8th-Order Active Low Pass Filter, 0.0001 to 50kHz, Elliptic Response, 1.5 Transition Ratio, Clock Tunable, 50:1 Clock to Cutoff Frequency, ±5V Max supply, SOIC-8
- Pins
- 8
- Pads
- 8
- SMD
- 7.4×5.4
MCP25625x-x-SS
Interface_CAN_LIN
Stand-Alone CAN Controller with SPI Interface and integated Transceiver, SSOP-28
- Pins
- 28
- Pads
- 28
- SMD
- 9.4×10.7
MCP23017x-x-SS
Interface_Expansion
16-bit I/O expander, I2C, interrupts, w pull-ups, SSOP-28
- Pins
- 28
- Pads
- 28
- SMD
- 9.4×10.7
MCP2221AxSL
Interface_USB
USB to I2C/UART Protocol Converter with GPIO, SOIC-14
- Pins
- 14
- Pads
- 14
- SMD
- 7.4×9.2
MOCD217M
Isolator
8-pin SOIC Dual-Channel Phototransistor Output Optocoupler, VCEO 30V, VF 1.05-1.3V (IF 1mA), CTR 100%, SOIC8
- Pins
- 8
- Pads
- 8
- SMD
- 7.4×5.4
MK20FX512VMD12
MCU_NXP_Kinetis
Kinetis K20 series, 120-MHz/32-bit ARM Cortex-M4, 512 kB flash, 512 kB FlexNVM, 128 kB SRAM, 16 kB FlexRAM, USB HS+FS Device/OTG, MAPBGA-144
- Pins
- 144
- Pads
- 144
- SMD
- 15.0×15.0
MKL27Z128VFT4
MCU_NXP_Kinetis
Kinetis KL27 series, 48-MHz/32-bit ARM Cortex-M0+, 128 kB flash, 32 kB SRAM, USB FS Device (xtal-less)/OTG, QFN-48
- Pins
- 49
- Pads
- 49
- SMD
- 8.3×8.3
MC9S08AW32xPUE
MCU_NXP_S08
8-bit General Purpose Microcontroller, S08 core, 32kB Flash, 2kB RAM, LQFP-64
- Pins
- 64
- Pads
- 64
- SMD
- 13.4×13.4
MC9S08DZ32xLF
MCU_NXP_S08
8-bit Cost-Effective Microcontroller, S08 core, 32kB Flash, 2kB RAM, 1kB EEPROM, LQFP-48
- Pins
- 48
- Pads
- 48
- SMD
- 10.3×10.3
MC9S08DZ32xLH
MCU_NXP_S08
8-bit Cost-Effective Microcontroller, S08 core, 32kB Flash, 2kB RAM, 1kB EEPROM, LQFP-64
- Pins
- 64
- Pads
- 64
- SMD
- 13.4×13.4
MC9S08LG32J0xLF
MCU_NXP_S08
8-bit Segment LCD Microcontroller, S08 core, 32kB Flash, 1984B RAM, LQFP-48
- Pins
- 48
- Pads
- 48
- SMD
- 10.3×10.3