Components

465 components matching “+-1”

A component is a schematic symbol with, where the catalog has them, its footprint and 3D package model — linked by KiCad's own references and cross-checked pin by pin.

I need

Symbol Footprint 3D model

Any part. Pick what you need to narrow it down.

465 components · page 3 of 20

Matched by name and keywords. Search by meaning instead

LTC2856xMS8-1

SYMFP3D

Interface_UART

RS-485, RS-422 Half duplex 20Mbps transceiver, MSOP-8

Pins: 8
Pads: 8
SMD: 6.4×3.5

LTC2857xDD-1

SYMFP3D

Interface_UART

RS-485, RS-422 Full duplex 250kbps transceiver, DFN-8

Pins: 9
Pads: 9
SMD: 4.0×3.6

LTC2857xMS8-1

SYMFP3D

Interface_UART

RS-485, RS-422 Full duplex 20Mbps transceiver, MSOP-8

Pins: 8
Pads: 8
SMD: 6.4×3.5

LTC2858xDD-1

SYMFP3D

Interface_UART

RS-485, RS-422 Full duplex 20Mbps transceiver, DFN-10

Pins: 11
Pads: 11
SMD: 4.3×3.5

LTC2858xMS-1

SYMFP3D

Interface_UART

RS-485, RS-422 Full duplex 20Mbps transceiver, MSOP-10

Pins: 10
Pads: 10
SMD: 6.2×3.5

PS8802-1

SYMFP3D

Isolator

Single DC Optocoupler Base Connected, Vcc 35V, CTR 15%, Viso 2500V, SSOP-8

Pins: 8
Pads: 8
SMD: 7.2×5.7

SFH601-1

SYMFP3D

Isolator

Optocoupler, phototransistor output with base connection, CTR 40-80%, Vceo 100V, Viso 5000Vrms, DIP-6

Pins: 6
Pads: 6
THT: 9.7×8.1

CR2032_CR2032-BS-6-1

SYMFP3D

kiml-00-kiml-battery

Single-cell battery Battery base CR2032 SMD Battery Connectors

Pins: 2
Pads: 2
SMD: 32.9×21.4

U.FL_BWIPX-1-001E

SYMFP3D

kiml-00-kiml-connector-coaxial

1 Inner needle IPEX Board Edge 6GHz 50Ω SMD RF

Pins: 2
Pads: 2
SMD: 4.3×5.0

LPC433xxET100

SYMFP3D

MCU_NXP_LPC

32-bit ARM Cortex-M4/M0 MCU, 512 KB / 1 MB Flash, 136 KB SRAM, 2 High-Speed USB 2.0, EMC (External Memory Controller), TFBGA-100 (NXP SOT926-1)

Pins: 100
Pads: 100
SMD: 11.0×11.0

AAT4616IGV-1-T1

SYMFP3D

Power_Management

Adjustable Current Limited Load Switch, SOT-23-5

Pins: 5
Pads: 5
SMD: 4.1×3.4

LM5067MM-1

SYMFP3D

Power_Management

Negative Hot Swap / Inrush Current Controller with Power Limiting, TSSOP-10 (Texas DGS0010A / VSSOP)

Pins: 10
Pads: 10
SMD: 6.3×3.5

LM5067MMX-2

SYMFP3D

Power_Management

Negative Hot Swap / Inrush Current Controller with Power Limiting, TSSOP-10 (Texas DGS0010A / VSSOP)

Pins: 10
Pads: 10
SMD: 6.3×3.5

LM5067MWX-1

SYMFP3D

Power_Management

Negative Hot Swap / Inrush Current Controller with Power Limiting, SOIC-14W

Pins: 10
Pads: 14
SMD: 11.9×9.5

LM5069MM-1

SYMFP3D

Power_Management

Hot swap & Inrush current controller with power limiting, latch off on fault, 9V to 80Vin, UVLO & OVLO, VSSOP-10

Pins: 10
Pads: 10
SMD: 6.2×3.5

LT1641-1

SYMFP3D

Power_Management

High voltage hot swap controller, +9V to +80V, with latching feature, SOIC-8

Pins: 8
Pads: 8
SMD: 7.4×5.4

LTC4365DDB-1

SYMFP3D

Power_Management

UV, OV and Reverse Supply Protection Controller, 1ms fault recovery, DFN-8

Pins: 9
Pads: 9
SMD: 3.3×3.5

LTC4365TS8-1

SYMFP3D

Power_Management

UV, OV and Reverse Supply Protection Controller, 1ms fault recovery, TSOT23-8

Pins: 8
Pads: 8
SMD: 4.1×3.4

MIC2587-1

SYMFP3D

Power_Management

Positive high voltage hot swap controller +10V to +80V with latched operation

Pins: 8
Pads: 8
SMD: 7.4×5.4

MIC2587R-1

SYMFP3D

Power_Management

Positive high voltage hot swap controller +10V to +80V with auto-retry operation

Pins: 8
Pads: 8
SMD: 7.4×5.4

LTC3890-1

SYMFP3D

Regulator_Controller

60V dual 2-phase synchronous step-down DC/DC controller, SSOP-28

Pins: 28
Pads: 28
SMD: 6.9×10.4

LTC3260xDE

SYMFP3D

Regulator_SwitchedCapacitor

Low Noise Dual Supply Inverting Charge Pump with both positive and negative LDO regulators, V_{IN} range 4.5V to 32V, 50 mA LDO output current, DFN-14-1EP

Pins: 15
Pads: 15
SMD: 4.1×4.6