Components
498 components matching “T-1”
A component is a schematic symbol with, where the catalog has them, its footprint and 3D package model — linked by KiCad's own references and cross-checked pin by pin.
LTC2856xMS8-1
Interface_UART
RS-485, RS-422 Half duplex 20Mbps transceiver, MSOP-8
- Pins
- 8
- Pads
- 8
- SMD
- 6.4×3.5
LTC2857xDD-1
Interface_UART
RS-485, RS-422 Full duplex 250kbps transceiver, DFN-8
- Pins
- 9
- Pads
- 9
- SMD
- 4.0×3.6
LTC2857xMS8-1
Interface_UART
RS-485, RS-422 Full duplex 20Mbps transceiver, MSOP-8
- Pins
- 8
- Pads
- 8
- SMD
- 6.4×3.5
LTC2858xDD-1
Interface_UART
RS-485, RS-422 Full duplex 20Mbps transceiver, DFN-10
- Pins
- 11
- Pads
- 11
- SMD
- 4.3×3.5
LTC2858xMS-1
Interface_UART
RS-485, RS-422 Full duplex 20Mbps transceiver, MSOP-10
- Pins
- 10
- Pads
- 10
- SMD
- 6.2×3.5
PS8802-1
Isolator
Single DC Optocoupler Base Connected, Vcc 35V, CTR 15%, Viso 2500V, SSOP-8
- Pins
- 8
- Pads
- 8
- SMD
- 7.2×5.7
SFH601-1
Isolator
Optocoupler, phototransistor output with base connection, CTR 40-80%, Vceo 100V, Viso 5000Vrms, DIP-6
- Pins
- 6
- Pads
- 6
- THT
- 9.7×8.1
CR2032_CR2032-BS-6-1
kiml-00-kiml-battery
Single-cell battery Battery base CR2032 SMD Battery Connectors
- Pins
- 2
- Pads
- 2
- SMD
- 32.9×21.4
U.FL_BWIPX-1-001E
kiml-00-kiml-connector-coaxial
1 Inner needle IPEX Board Edge 6GHz 50Ω SMD RF
- Pins
- 2
- Pads
- 2
- SMD
- 4.3×5.0
MCP4017T-104E
kiml-00-kiml-potentiometer-digital
Low-Cost 128-Step Volatile I2C Digital Potentiometer, SC-70-6
- Pins
- 6
- Pads
- 6
- SMD
- 2.9×2.2
LPC433xxET100
MCU_NXP_LPC
32-bit ARM Cortex-M4/M0 MCU, 512 KB / 1 MB Flash, 136 KB SRAM, 2 High-Speed USB 2.0, EMC (External Memory Controller), TFBGA-100 (NXP SOT926-1)
- Pins
- 100
- Pads
- 100
- SMD
- 11.0×11.0
AAT4616IGV-1-T1
Power_Management
Adjustable Current Limited Load Switch, SOT-23-5
- Pins
- 5
- Pads
- 5
- SMD
- 4.1×3.4
LM5067MM-1
Power_Management
Negative Hot Swap / Inrush Current Controller with Power Limiting, TSSOP-10 (Texas DGS0010A / VSSOP)
- Pins
- 10
- Pads
- 10
- SMD
- 6.3×3.5
LM5067MMX-2
Power_Management
Negative Hot Swap / Inrush Current Controller with Power Limiting, TSSOP-10 (Texas DGS0010A / VSSOP)
- Pins
- 10
- Pads
- 10
- SMD
- 6.3×3.5
LM5067MWX-1
Power_Management
Negative Hot Swap / Inrush Current Controller with Power Limiting, SOIC-14W
- Pins
- 10
- Pads
- 14
- SMD
- 11.9×9.5
LM5069MM-1
Power_Management
Hot swap & Inrush current controller with power limiting, latch off on fault, 9V to 80Vin, UVLO & OVLO, VSSOP-10
- Pins
- 10
- Pads
- 10
- SMD
- 6.2×3.5
LT1641-1
Power_Management
High voltage hot swap controller, +9V to +80V, with latching feature, SOIC-8
- Pins
- 8
- Pads
- 8
- SMD
- 7.4×5.4
LTC4365DDB-1
Power_Management
UV, OV and Reverse Supply Protection Controller, 1ms fault recovery, DFN-8
- Pins
- 9
- Pads
- 9
- SMD
- 3.3×3.5
LTC4365TS8-1
Power_Management
UV, OV and Reverse Supply Protection Controller, 1ms fault recovery, TSOT23-8
- Pins
- 8
- Pads
- 8
- SMD
- 4.1×3.4
MIC2587-1
Power_Management
Positive high voltage hot swap controller +10V to +80V with latched operation
- Pins
- 8
- Pads
- 8
- SMD
- 7.4×5.4
MIC2587R-1
Power_Management
Positive high voltage hot swap controller +10V to +80V with auto-retry operation
- Pins
- 8
- Pads
- 8
- SMD
- 7.4×5.4
LTC3890-1
Regulator_Controller
60V dual 2-phase synchronous step-down DC/DC controller, SSOP-28
- Pins
- 28
- Pads
- 28
- SMD
- 6.9×10.4
LM1117DT-1.8
Regulator_Linear
800mA Low-Dropout Linear Regulator, 1.8V fixed output, TO-252
- Pins
- 3
- Pads
- 3
- SMD
- 11.1×7.0
LM341T-12_TO220
Regulator_Linear
Positive 500mA 35V Linear Regulator, Fixed Output 12V, TO-220
- Pins
- 3
- Pads
- 3
- THT
- 10.5×4.9