Components
3,394 matching
Each one is a symbol, its recommended footprint and its 3D package model, linked by KiCad's own references and cross-checked pin by pin.
32M_7M32000022
kiml-00-kiml-crystal
32MHz 10pF ±10ppm SMD3225-4P Crystals
- Pins
- 4
- Pads
- 4
- SMD
- 4.2×3.5
32.4R_0402_AC0402FR-0732R4L
kiml-00-kiml-resistors-smd
62.5mW Thick Film Resistors ±100ppm/℃ ±1% 32.4Ω 0402
- Pins
- 2
- Pads
- 2
- SMD
- 1.9×0.9
320S14-U
Transistor_BJT
4 Matched PNP Transistors, hfe=75, SOIC-14
- Pins
- 14
- Pads
- 14
- SMD
- 7.4×9.2
ESP32-WROOM-32
RF_Module
RF Module, ESP32-D0WDQ6 SoC, Wi-Fi 802.11b/g/n, Bluetooth, BLE, 32-bit, 2.7-3.6V, onboard antenna, SMD
- Pins
- 39
- Pads
- 39
- SMD
- 48.0×41.3
ESP32-S3-WROOM-1
RF_Module
RF Module, ESP32-S3 SoC, Wi-Fi 802.11b/g/n, Bluetooth, BLE, 32-bit, 3.3V, onboard antenna, SMD
- Pins
- 41
- Pads
- 41
- SMD
- 48.0×41.2
STM32F103C8Tx
MCU_ST_STM32F1
STMicroelectronics Arm Cortex-M3 MCU, 64KB flash, 20KB RAM, 72 MHz, 2.0-3.6V, 37 GPIO, LQFP48
- Pins
- 48
- Pads
- 48
- SMD
- 10.3×10.3
ATmega328-P
MCU_Microchip_ATmega
20MHz, 32kB Flash, 2kB SRAM, 1kB EEPROM, DIP-28
- Pins
- 28
- Pads
- 28
- THT
- 9.7×36.1
ESP32-C3-WROOM-02
RF_Module
802.11 b/g/n WiFi and Bluetooth 5 module, ESP32C3 SoC, RISCV microprocessor, On-board antenna
- Pins
- 19
- Pads
- 19
- SMD
- 28.5×25.5
ATmega32U4-A
MCU_Microchip_ATmega
16MHz, 32kB Flash, 2.5kB SRAM, 1kB EEPROM, USB 2.0, TQFP-44
- Pins
- 44
- Pads
- 44
- SMD
- 13.3×13.3
ESP32-WROOM-32D
RF_Module
RF Module, ESP32-D0WD SoC, Wi-Fi 802.11b/g/n, Bluetooth, BLE, 32-bit, 2.7-3.6V, onboard antenna, SMD
- Pins
- 39
- Pads
- 39
- SMD
- 48.5×41.5
ATmega32U4-M
MCU_Microchip_ATmega
16MHz, 32kB Flash, 2.5kB SRAM, 1kB EEPROM, USB 2.0, QFN-44
- Pins
- 45
- Pads
- 45
- SMD
- 8.3×8.3
W25Q32JVSS
Memory_Flash
32Mbit / 4MiB Serial Flash Memory, Standard/Dual/Quad SPI, 2.7-3.6V, SOIC-8 (208 mil)
- Pins
- 8
- Pads
- 8
- SMD
- 9.3×5.8
FT2232HL
Interface_USB
Hi Speed Double Channel USB UART/FIFO, LQFP-64
- Pins
- 64
- Pads
- 64
- SMD
- 13.4×13.4
ATmega328P-A
MCU_Microchip_ATmega
20MHz, 32kB Flash, 2kB SRAM, 1kB EEPROM, TQFP-32
- Pins
- 32
- Pads
- 32
- SMD
- 10.3×10.3
Arduino_Nano_ESP32
MCU_Module
Arduino Nano board based on the ESP32-S3 with a dual-core 240 MHz processor, 384 kB ROM, 512 kB SRAM. Operates at 3.3V, with 5V USB-C® input and 6-21V VIN. Features Wi-Fi®, Bluetooth® LE, digital and analog pins, and supports SPI, I2C, UART, I2S, and CAN.
- Pins
- 30
- Pads
- 30
- THT
- 18.3×46.2
STM32F303K8Tx
MCU_ST_STM32F3
STMicroelectronics Arm Cortex-M4 MCU, 64KB flash, 16KB RAM, 72 MHz, 2.0-3.6V, 25 GPIO, LQFP32
- Pins
- 32
- Pads
- 32
- SMD
- 10.4×10.4
DS3231MZ
Timer_RTC
±5ppm, I2C Real-Time Clock SOIC-8
- Pins
- 8
- Pads
- 8
- SMD
- 7.4×5.4
TPA6132A2RTE
Amplifier_Audio
25mW, Stereo, DirectPath Audio Amplifier, WQFN-16
- Pins
- 17
- Pads
- 17
- SMD
- 4.3×4.3
LM321
Amplifier_Operational
Low Power Single Operational Amplifier, SOT-23-5
- Pins
- 5
- Pads
- 5
- SMD
- 4.1×3.4
PCM5102A
Audio
2.1 VRMS, 112dB Audio Stereo DAC with PLL and 32-bit, 384kHz PCM Interface, TSSOP-20
- Pins
- 20
- Pads
- 20
- SMD
- 7.7×7.0
Choke_Wurth_WE-CNSW_744232090
Filter
Common mode choke, 370 mA, 125VDC, USB2.0, 111 nH
- Pins
- 4
- Pads
- 4
- SMD
- 4.3×2.1
MAX3490xSA
Interface_UART
Full duplex RS-485/RS-422, 10Mbps, slew-rate limited, no low-power shutdown, no with receiver/driver enable, 32 receiver drive capability, SOIC-8
- Pins
- 8
- Pads
- 8
- SMD
- 7.4×5.4
MAX485E
Interface_UART
Half duplex RS-485/RS-422, 2.5 Mbps, ±15kV electro-static discharge (ESD) protection, no slew-rate, no low-power shutdown, with receiver/driver enable, 32 receiver drive capability, DIP-8 and SOIC-8
- Pins
- 8
- Pads
- 8
- SMD
- 7.4×5.4
FT232RL
Interface_USB
USB to Serial Interface, SSOP-28
- Pins
- 26
- Pads
- 28
- SMD
- 9.4×10.7